GSO ISO 21940-13:2016
Gulf Standard
Current Edition
·
Approved on
22 December 2016
·
Mechanical vibration -- Rotor balancing -- Part 13: Criteria and safeguards for the in-situ balancing of medium and large rotors
GSO ISO 21940-13:2016 Files
English
23 Pages
Current Edition
Reference Language
153.28 USD
GSO ISO 21940-13:2016 Scope
This part of ISO 21940 specifies procedures to be adopted when balancing medium and large rotors installed in their own bearings on site. It addresses the conditions under which it is appropriate to undertake in-situ balancing, the instrumentation required, the safety implications and the requirements for reporting and maintaining records.
This part of ISO 21940 can be used as a basis for a contract to undertake in-situ balancing.
It does not provide guidance on the methods used to calculate the correction masses from measured vibration data.
NOTE The procedures covered in this part of ISO 21940 are suitable for medium and large machines. However, many of the principles are equally applicable to machines of a smaller size, where it is necessary to maintain good records of the vibration behaviour and the correction mass configurations.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ISO 11114-6:2024
ISO 11114-6:2022
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 6: Oxygen pressure surge testing
GSO EN 14622:2024
EN 14622:2005
Gulf Standard
Devices to prevent pollution by backflow of potable water - Air gap with circular overflow (restricted) - Family A, type F
GSO ISO 23598:2024
ISO 23598:2021
Gulf Standard
Mechanical joining of sheet materials — Destructive testing of joints — Specimen dimensions and procedure for mechanized peel testing of single joints
GSO BS 1212-2:2024
BS 12122:1990
Gulf Standard
Float operated valves - Part 2: Specification for diaphragm type float operated valves (copper alloy body) (excluding floats)