GSO ISO/TS 13471-1:2023
Gulf Standard
Current Edition
·
Approved on
03 May 2023
·
Acoustics — Temperature influence on tyre/road noise measurement — Part 1: Correction for temperature when testing with the CPX method
GSO ISO/TS 13471-1:2023 Files
English
15 Pages
Current Edition
Reference Language
114.07 USD
GSO ISO/TS 13471-1:2023 Scope
ISO/TS 13471-1:2017 specifies procedures for determining the effect of temperature on tyre/road noise emission. Temperatures considered are tyre, road and ambient air temperatures.
The noise emission for which this document is applicable is measured by means of ISO 11819‑2, or similar methods such as the on-board sound intensity (OBSI) method specified in Reference [1]. Measurement results obtained at a certain temperature, which may vary over a wide range, are normalized to a designated reference temperature (20 °C) using a correction procedure specified in this document.
Best Sellers From Metrology Sector
GSO OIML R87:2021
OIML R87:2016
Gulf Standard
Quantity of product in prepackages
GSO OIML R79:2021
OIML R79:2015
Gulf Standard
Labeling requirements for prepackages
GSO OIML R 76-1:2009
OIML R 76-1:2006
Gulf Standard
Non-automatic weighing instruments –
Part 1: Metrological and technical requirements - Tests
GSO OIML R111-1:2007
OIML R111-1:2004
Gulf Standard
Weights of classes E1, E2,F1,F2,M1,M1-2,M2,M2-3 and M3
Part 1: Metrological and Technical requirements
Recently Published from Metrology Sector
GSO ISO 12999-2:2024
ISO 12999-2:2020
Gulf Standard
Acoustics — Determination and application of measurement uncertainties in building acoustics — Part 2: Sound absorption
GSO ISO 3864-2:2024
ISO 3864-2:2016
Gulf Standard
Graphical symbols — Safety colours and safety signs — Part 2: Design principles for product safety labels
GSO ISO 12179:2024
ISO 12179:2021
Gulf Standard
Geometrical product specifications (GPS) — Surface texture: Profile method — Calibration of contact (stylus) instruments
GSO ISO 14405-2:2024
ISO 14405-2:2018
Gulf Standard
Geometrical product specifications (GPS) — Dimensional tolerancing — Part 2: Dimensions other than linear or angular sizes